Siemens Network Communication Control Training Kit Process Control Trainer Didactic Equipment Teaching Equipment

I.Product Overview

1.1 Overview

The Siemens network communication control training kit contains two parts: the actuator unit and the console.
Actuator: It is built with an aluminum alloy frame, including a water tank, a water pump, a pneumatic proportional valve, a heater, a flow sensor, a temperature sensor, a pressure sensor, etc., which can realize cascade control and PID control;
The console is also an aluminum alloy frame, including a power box, a computer, a PLC, a communication module, etc., which can hold a double-layer module hanging box unit. The PLC module wiring uses K4 terminals to transfer to the hanging box panel.
System Overview of the Siemens Network Communication Control Training Kit:
1. The system host computer uses the configuration software to monitor data and remotely control. The PLC adopts the Siemens brand, with an S7-1513+DP as the master module and an S7-1214+DP as the slave module. The master and slave stations support DP and Ethernet communication.
2. The water pump of the actuator is controlled by Siemens G120 inverter. The inverter can adjust the speed of the water pump in real time according to the analog output signal or communication method of PLC, so as to achieve the purpose of controlling the flow.
3. The instruments and sensors of the actuator are connected to PLC-S7-1214 through DP/PA coupler and AFD for communication.
4. The actuator is equipped with 2 pressure sensors and temperature sensors supporting DP protocol, which can provide ring network communication, multi-point communication and point-to-point communication
5. The actuator is equipped with 2 pressure sensors and temperature sensors supporting PA protocol, which can provide ring network communication, multi-point communication and point-to-point communication
6. The actuator is equipped with 2 pressure sensors and temperature sensors of HART protocol, which can provide ring network communication, multi-point communication and point-to-point communication
7. Configure a remote button hanging box with Siemens remote I/O module inside, and realize remote start and stop control of the equipment through Ethernet communication.

II.Performance Parameter

2.1 Technical Parameters

Power supply parameters: three-phase five-wire 380V
Siemens G120 inverter parameters: 6SL3210-1PE11-8UL1 Input: 3*400-480V, output: 0-input voltage
Siemens PLC Siemens 1214C DC/DC/DC (6ES7 214-1AG40-0XB0)
Siemens 6ES7 511-1CK01-0AB0 PLC CPU 1511C-1 PN DI16/DQ16, AI5/AQ2
RS485 signal board CB1241 6ES7 241-1CH30-1XB0
Siemens PLC analog expansion module 6ES7 232-4HB32-0XB0 SM 1232 AQ 2 x 14 bits
Siemens DP module CM1542-5 6GK7 542-5DX00-0XE0

2.2 Dimensions and Weight

Size 1: Length 2130mm Width 752mm Height 2055mm
Weight 1:<427kg
Size 2: 1705mm Width 703mm Height 1736mm
Weight 2:<234kg

III.Components List and Detailed Introduction

3.1 Main Part

3.2 Electrical Part

3.3 Accessories

IV.Product Configuration List

V.Experiment list
1.Heater PID temperature control experiment
2.Water pump level PID control experiment
3.Water pump pressure PID control experiment
4.Proportional valve flow PID control experiment